高質のH3C試験資料を持って、短い時間で気軽に試験に合格したいですか？そうしたら、我が社TopexamのConstructing H3C High-Performance Campus Networks問題集をご覧にください。我々Constructing H3C High-Performance Campus Networks資料は認定試験の改革に準じて更新していますから、お客様は改革での問題変更に心配するは全然ありません。お客様か購入する前、我が社TopexamのConstructing H3C High-Performance Campus Networks問題集の見本を無料にダウンロードできます。

我が社のTopexamはいつまでもお客様の需要を重点に置いて、他のサイトに比べより完備のConstructing H3C High-Performance Campus Networks試験資料を提供しConstructing H3C High-Performance Campus Networks試験に参加する人々の通過率を保障できます。

一年の無料更新提供

Topexamは最高の資材を提供するだけではなく、優れたサービスも提供しています。Topexam質問と回答を購入した場合、一年間の無料更新を保証します。

助けなく、100%全額返金

我々のH3C　GB0-371-ENU試験問題を使用した後、もし試験に失敗すれば、 100%全額返金を保証します。不合格の証明書をスキャンして、メールでこちらに送ることだけが必要です。確認した後、こちらは返金します。

GB0-371-ENU試験問題集をすぐにダウンロード：成功に支払ってから、我々のシステムは自動的にメールであなたの購入した商品をあなたのメールアドレスにお送りいたします。（12時間以内で届かないなら、我々を連絡してください。Note：ゴミ箱の検査を忘れないでください。）

短時間で万全の試験準備

我々はConstructing H3C High-Performance Campus Networksの試験資材を絶えず更新しています。我々は、最新の試験問題とほとんど全ての知識をカバーする質問と回答を顧客に提供します。これは簡単にConstructing H3C High-Performance Campus Networks試験の準備とうまく試験に合格するのを助けます。あなたは、ただ20〜30時間をかかって試験ダンプを勉強する必要があります。

H3C Constructing H3C High-Performance Campus Networks 認定 GB0-371-ENU 試験問題:

1. Which of the following descriptions about exact matching switches and longest matching switches is correct?

A) The longest matching switch replaces the software routing table with hardware entries, and follows the longest matching principle when searching. In the case of extremely serious network worms, it can still guarantee the wire-speed forwarding of IP packets
B) The longest matching switch uses software to search the routing table for
C) The exact matching switch is to complete the forwarding of subsequent packets through hardware after the first packet is searched and processed by software, but it cannot cope with the impact of worms on routing
D) The exact matching switch searches the routing table through software for packet-by-packet forwarding

2. The customer LAN switches SWA, SWB, and SWC form the RRPP ring main ring 1, and the switch SWA has the following configuration information:
[SWA] rrpp domain 1
[SWA-rrpp-domain1] control-vlan 4092
If the switch SWA ports Gigabitethernet 1/0/1 and Gigabitethernet 1/0/2 are connected to the RRPP ring, we can know from the above information

A) If SWA is the master node, the functions of GigabitEthernet 1/0/1 and GigabitEthem 1/0/ 1/0/2 are the same
B) If SWA is a transmission node, the functions of Gigabitethernet1/0/1 and Gigabitethernet1/0/2 are the same
C) If SWA is the master node, when the R&PP ring is in a healthy state, the SWA secondary port only allows VLAN4092 to pass
D) If SWA is a transit node, when the RRPP ring is in a healthy state, the SWA main port only allows VLAN4092 to pass

3. As shown in the networking, there is no connection between SWA and SWB at the beginning, and RSTP is enabled for SWA and SWB. When the topology is stable, connect the port E1/0/1 of SWA and SWB. Assuming that SWA will become the new root bridge, the following The correct statement is

A) Port E1/0/1 of SWA and SWB will send Proposal message to request to enter forwarding state
B) When SWB receives the Proposal message sent by SWA, it will immediately reply to the Agreement message
C) SWB does not need to generate BPDUs by itself, and the content of the Agreement message in response is copied from the Proposal message sent by SWA
D) When SWB receives the Proposal message sent by SWA, it will start the synchronization process to block the old root port, designated port and edge port

4. The figure shows the networking application of SmartLink and Monitor Link. The Smart Link group is configured on the switch SWD, and the Monitor Link group is configured on the switch SWB and switch SWC. The switch SWB is connected to the switch SWA port as the Monitor Link uplink port, and the switch SWB is connected to the switch SWD port. Monitor Link downlink port: The opposite port of the downlink port is the switch SWDSmart Link group port, which can be known from the above information

A) The link of the upstream switch SWA of the switch SWB is Down, and the status of the Smart Link group of the corresponding port of the switch SWD must change
B) The link of the switch SWB uplink switch SWA is Down, and the status of the Smart Link group of the corresponding port of the switch SWD may not change
C) The link of the upstream switch SWB of the switch SWD is Down, and the status of the upstream port of the switch SWBMonitor Link group may not change
D) The link of the switch SWD upstream switch SWB is Down, and the status of the upstream port of the switch SWBMonitor Link group must change

5. Regarding the configuration of the spanning tree protection mechanism, the following statements are correct

A) BPDU protection needs to be configured in the view of the port designated as an edge port
B) Only when the root bridge protection command is configured on the root bridge in the network will it play a protective role
C) Loop protection commands need to be configured on each port on the physical loop
D) After the TC protection threshold is configured, if the number of TC packets received by the device within the default 10 seconds exceeds the threshold, the device will no longer delete the address table entry within these 10 seconds

質問と回答：

質問 # 1
正解： A、C

質問 # 2
正解： B、C

質問 # 3
正解： A、C

質問 # 4
正解： B、C

質問 # 5
正解： D